2010 Mercury Mariner
Mileage
85,234
Service Date
6/26/2024
Services Performed
- DIAGNOSE AND/OR REPAIR
- LUBRICATE AND CHECK CHASSIS. CHANGE OIL, CHANGE OIL FILTER. CHECK AIR FILTER AND BREATHER FILTER. CHECK ALL FLUID LEVELS AND TIRE PRESSURES. PERFORM BASIC SAFETY INSPECTION.
- REPLACE THE FRONT BRAKE PADS. REPLACE THE FRONT BRAKE ROTORS. CLEAN AND LUBE THE CALIPER SUPPORTS AND THE SLIDE MECHANISMS.REPLACE THE HARDWARE KIT IF NECESSARY. CLEAN AND REPACK THE WHEEL BEARINGS AND REPLACE THE SEALS IF EQUIPPED. BLEED THE BRAKE IF NECESSARY. CHECK AND FILL THE BRAKE FLUID. TORQUE THE LUG NUTS AND TEST DRIVE THE VEHICLE. NOTE: SUBSEQUENT OVER TORQUING OF THE LUG NUT CAN AND WILL DAMAGE THE BRAKE ROTOR(S). THIS WILL CAUSE PULSATION. WE USE A TORQUE BAR TO ENSURE THAT THE LUG NUT TORQUE IS CORRECT, EVERY TIME. IF THE LUG NUTS ARE OVER TORQUED, WE CANNOT WARRANTY THE PARTS, NOR THE LABOR. THIS IS AN EXCEPTION TO OUR 2YR/24K MILE WARRANTY.
- DURING OUR INSPECTION WE FOUND THAT 2 OF THE HIGH MOUNT BRAKE LIGHTS WERE OUT. REMOVE AND REPLACE ALL 5 HIGH MOUNT BRAKE LIGHTS.
- DURING OUR INSPECTION WE FOUND THAT THE AIR FILTER WAS DIRTY. REMOVE AND REPLACE AIR FILTER.
- WE EVACUATE THE SYSTEM, PULL VACUUM TO REMOVE MOISTURE AND CHECK FOR LEAKS. RECHARGE THE SYSTEM, IF NECESSARY, ADD DYE TO THE SYSTEM IN ORDER TO SPOT FUTURE LEAKS.
- DURING OUR INSPECTION WE FOUND THAT THE AC CONDENSER WAS LEAKING. REMOVE AND REPLACE THE AC CONDENSER.
- DURING OUR INSPECTION WE FOUND THAT THE AC PRESSURE SWITCH WAS FAILING. REMOVE AND REPLACE AC PRESSURE SWITCH.
- WE CHECKED AT THE COMPRESSOR AND FOUND THAT THERE WAS NO POWER AT THE COMPRESSOR. WE TRACKED AND TESTED THE SYSTEM, WE FOUND THAT THE AC PRESSURE SWITCH WAS NOT WORKING. SEE APPROPRIATE LABOR FOR FURTHER INFORMATION.
- THANK YOU!
FRANCES N. gave our service a 5 star review on 6/27/2024
